01 / AXES
Three-Axis Motion Layout
The simulator combines bounded Roll and Pitch movement with continuous Yaw rotation.
- Roll angular freedom: ±105°
- Pitch angular freedom: ±105°
- Yaw angular freedom: Continuous
- Direct / AC brushless motors
S12 is a three-axis simulator combining manually positioned Roll and Pitch axes with a motorized Yaw axis. The official sheet lists continuous Yaw rotation, ±150°/s Yaw rate capability, 15 kg UUT capacity, direct AC brushless motors, and a mixed manual/motorized positioning architecture.
Roll and Pitch are manually positioned while Yaw is motorized.
The outer Yaw axis provides continuous angular freedom and active rate control.
The official sheet lists a maximum Unit Under Test weight of 15 kg.
80 lines at 1 A and 30 lines at 3 A provide electrical access to the UUT.
The S12 is presented as a three-axis simulator with Roll, Pitch, and Yaw. Roll and Pitch have angular freedom of ±105°, while the outer Yaw axis is listed as continuous.
The position mechanism is manual for Roll and Pitch and motorized for Yaw. Locking positions are specified in increments of 15° for Roll and Pitch and 5° for Yaw.
The UUT specification block lists a 15 kg maximum UUT weight, UUT dimensions of Ø229 × 600 mm, and electrical routing through 80 lines at 1 A plus 30 lines at 3 A.
Motion, positioning, rate, and UUT-interface characteristics stated in the official S12 sheet.
The simulator combines bounded Roll and Pitch movement with continuous Yaw rotation.
Positioning strategy differs by axis.
Each axis has specified locking increments and positioning performance.
The platform provides multiple power/current classes for the connected test article.
Manual axis
Manual axis
Motorized axis
Over 360°
The rate section applies to the motorized outer Yaw axis, listing ±150°/s range, ±0.001°/s resolution, and accuracy & stability better than 50 ppm. Dynamic data lists 7 Hz bandwidth and >100°/s² no-load acceleration.
Derived directly from the published specification blocks.
Roll is manually positioned through a ±105° angular envelope.
Pitch is manually positioned through a ±105° angular envelope.
The motorized Yaw axis provides continuous angular freedom.
Roll and Pitch lock every 15°, while Yaw locks every 5°.
The outer axis is rated for ±150°/s with ±0.001°/s resolution.
The outer axis is listed with 7 Hz bandwidth and acceleration above 100°/s².
The platform supports a maximum UUT weight of 15 kg.
110 electrical lines in two current classes support wired test articles.
The rate table is listed at 750 × 750 × 1300 mm and 85 kg.
Values below reproduce the official ACCUDYNA one-page product-sheet data.
One complete manufacturer sheet containing the UUT data, hybrid Roll / Pitch / Yaw configuration, manual and motorized positioning details, Yaw rate performance, dynamic data, and physical installation requirements.
The S12 sheet emphasizes a hybrid three-axis architecture, continuous motorized Yaw motion, precise Yaw positioning, a 15 kg UUT capacity, and extensive electrical access.
Manual Roll and Pitch, motorized Yaw
Continuous Yaw rotation
±150°/s Yaw rate range
80 lines 1 A + 30 lines 3 A to UUT
15 kg maximum UUT weight
Answers based on the official product sheet.
Discuss Roll and Pitch setup, continuous Yaw operation, UUT dimensions and wiring, rate performance, and installation constraints for your next three-axis simulator system.
Request a Quote →