01 / AXES
Continuous Roll + Pitch + Yaw
All three simulator axes provide continuous angular freedom.
- Inner axis: Roll
- Middle axis: Pitch
- Outer axis: Yaw
- Continuous angular freedom on all axes
S10-V1 is a three-axis simulator with continuous angular freedom on the inner Roll, middle Pitch, and outer Yaw axes. The official product sheet lists a 30 kg UUT capacity, high-resolution rate control, axis-specific speed and dynamic performance, and extensive electrical access to the Unit Under Test.
Roll, Pitch, and Yaw axes are all listed with continuous angular freedom.
The official sheet lists a maximum Unit Under Test weight of 30 kg.
Rate resolution is listed as ±0.0001°/s on all three axes.
92 lines at 3 A and 6 lines at 7 A provide electrical access to the test article.
The S10-V1 parameter sheet presents a three-axis simulator with inner Roll, middle Pitch, and outer Yaw axes. Angular freedom is listed as continuous on all three axes.
The UUT specification block lists a 30 kg maximum UUT weight, UUT dimensions of 236 × 275 × 282 mm, a hard-anodized aluminum table top, and electrical routing through 92 lines at 3 A plus 6 lines at 7 A.
Axis-dependent rate ranges are published as ±90°/s for Roll, ±60°/s for Pitch, and ±100°/s for Yaw, while all axes share a rate resolution of ±0.0001°/s and accuracy/stability better than 15 ppm.
Motion, position, dynamic, and UUT-interface characteristics stated in the official manufacturer sheet.
All three simulator axes provide continuous angular freedom.
The same position-performance values are listed across all three axes.
Each axis has its own maximum rate range while sharing the same resolution and stability class.
The platform supports a relatively heavy UUT and extensive electrical connectivity.
Inner axis
Middle axis
Outer axis
All three axes
The official sheet lists dynamic bandwidth above 20 Hz for Roll, above 30 Hz for Pitch, and above 15 Hz for Yaw. No-load acceleration is above 300°/s² on Roll and Pitch and above 500°/s² on Yaw.
Derived directly from the manufacturer’s published parameter blocks.
The inner axis supports continuous rotational motion.
The middle axis also provides continuous angular freedom.
The outer axis completes the continuous three-axis motion set.
Each axis is listed with ±60 arcsec accuracy and ±10 arcsec repeatability.
Rate resolution is ±0.0001°/s on Roll, Pitch, and Yaw.
Bandwidth and no-load acceleration are specified separately for each axis.
The platform supports a maximum UUT mass of 30 kg.
98 electrical lines in two current classes support wired test articles.
Physical dimensions, weight, floor geometry, and power requirements are published.
Values below reproduce the official ACCUDYNA one-page product-sheet data.
One complete manufacturer sheet containing UUT specifications, continuous Roll / Pitch / Yaw freedom, position data, axis-specific rate performance, dynamic characteristics, and physical installation requirements.
The official S10-V1 sheet emphasizes continuous three-axis rotation, fine rate resolution, strong axis dynamics, a 30 kg UUT capacity, and extensive electrical access to the test article.
Continuous Roll / Pitch / Yaw rotation
±90 / ±60 / ±100 °/s rate ranges
>20 / >30 / >15 Hz bandwidth
92 lines 3 A + 6 lines 7 A to UUT
30 kg maximum UUT weight
Answers based on the official product sheet.
Discuss continuous-axis operation, UUT mass and wiring requirements, rate performance, dynamic bandwidth, and installation constraints for your next three-axis simulator system.
Request a Quote →